Paxar 636, User Manual, Page: 75 / 115

Users Manual Model 656/636 Appendix D
•
69
•
There should be a .010-.020 gap (for roller clutch only) between the two clutch pieces.
•
(Test on the solenoid test box.) The knife must cut both fabric and card stock. The solenoid
should operate on both the high and low settings.
•
Excessive motor drag must be minimal at start/stop and while running. Replace or repair
problem component. On old knife assemblies, there are bronze bushings in outer support. They
may be causing a bind. Ream bushing and retest. (Do not ream if it is a roller bearing.)
•
(Rev 1) Pre-load setting adjustment. While motor is running, not while cutting, loosen set
screws on “pac-man” and rotate the rotary blade clockwise, mark the stopping position on the
“pac-man”, rotate counterclockwise, mark the “pac-man”, then rotate the blade to the middle of
the two marks and tighten the set screws.
•
(Rev 2) All new knife assemblies have a blue clutch. The clutch outer race bushing has an I.D.
of .500 and the 2 extension springs are .012 dia wire.
•
(Rev 2) The 2 extension springs on all rebuilt clutches must have the .009 dia. wire springs
replaced with .012 wire springs.
•
(Rev 5) Replace Knife Actuator 357020, if it is worn or if there is a “bulge” at the 90-degree
bend.
•
(Rev 6) Changed feeler gauge tolerance from .047 MIN