You can set The PATmicro to automatically send you a location at preset intervals
By default your PATmicro has been set up to wake from sleep mode every 10
minutes to figure out where it is and remember it but not report it. The period of
wake up can be changed by the following command. This can be set from 1 minute
to 1380 mins
By sending the following command the PATmicro will wake up, obtain its location and
send it to your phone in an sms
* SMS command to The PATmicro:
P Y 9
(in case of reporting every 9 mins)
* Reply from PATmicro:
HP=D001+SET POINT SEND TIME OK
Notes for command - You should allow a space between
P
and
Y
and also after
Y
If you just want to change the time period but do not want a position sent to you
then follow up with the following command.
* SMS command:
P N
* Reply:
HP=D001+SET POINT SEND TIME OK
Notes for command. You should allow a space between
P
and
N
Before you send the command to cancel period report, we recommend that you send
another command
P Y 10
to change the ‘wake-up’ time back to default status of
every 10mins. This will ensure that The PATmicro is operating under the most
efficient mode. You then follow this with the
P N
command to stop automatic
sending.
