Periodically check the gate for signs of damage,
wear, or missing components. Do not use if any
part is missing, worn or damaged. Check the
gate regularly to ensure all the hardware and
mountings are tightened. Do not use abrasive
cleaners or bleach. Clean by sponging with warm
water and a mild detergent.
CARE AND MAINTENANCE
To remove your gate from the wall, rotate the
adjustment wheels on each of the (4) threaded
spindle rods to depressurize the gate from its
doorway or opening. Then, gently pull or push the
gate free from its doorway or opening.
REMOVING YOUR GATE FROM THE WALL
• Improper installation could result in the gate
becoming unstable or dislodged from the doorway.
• Base locks are to be used at all times, on both
sides of the gate.
• This product will not necessarily prevent all
accidents.
• Check the gate regularly to see if all the
hardware and mountings are tightened.
• Do not use if any components are missing or
damaged.
• STOP using when a pet can climb over or
dislodge the gate.
• Additional or replacement parts should only be
obtained from the manufacturer or distributor.
IMPORTANT
USE AT THE TOP OF STAIRS
If the gate is used at the top of stairs, we recommend the
safe distanced to the 1st step is at least
16 inch
.
(Figure A)
Using the wall cups will affix your gate more firmly
in the doorway or opening.
Figure A
16 inch
OPERATING THE DOOR LATCH
Figure 4-1
Figure 4-2
Figure 4-3
To Open
- Ensure that the base locks at the bottom of the gate
door are in the horizontal position
(Figure 4-1)
.
Pull the spring lock
away from the easy open latch while simultaneously lifting the
lock lever upwards
(Figure 4-2 and 4-3)
. This will release the
locking latch from the gate frame and allow the door to push or
pull open.
To Close
- Pull the door shut and ensure that the door latch on
top closes and then place the lock at the bottom of the gate
down on the side occupied by the child, Gate will swing both
ways unless one of the swing stops is down. Gate will not swing
at all if both swing stops are down.
(Figure 4-4)
Figure 4-4
Once the gate is opened,it can close up automatically
and lock up.
When the opening width of the gate is
8 inch
, the gate has the
function of Automatic Closing
(Figure 4-5)
.
NOTE
When the gate opening width is greater than
23 inch
,
the gate will be normally open.
(Figure 4-6)
8 inch
Figure 4-5
Figure 4-6
23 inch
ADDING A GATE EXTENSION
STEP 1
Remove the top and bottom threaded
spindle rods.
(Figure 5-1)
STEP 2
Assemble the gate and extension as
illustrated
(Figure 5-2 and 5-3)
. Reposition
the gate and fit in accordance with the
gate fitting instructions.
NOTE:
It is preferable to install any
extensions on the hinge side of the gate.
Figure 5-2
Figure 5-1
Figure 5-3
