![background image](http://html.mh-extra.com/html/paw/44009/44009_owners-manual_764060017.webp)
Page 17
52.
POWER ASSIST OPERATION OF YOUR PAW
Use the same care when operating the PAW in both manual and/
or power assist modes.
53.
Turn
ON (I)
the power switch located on the electronics box. The battery indicator lights should
illuminate on the top of the control module mounted on the right handle. (If they do not illuminate see
the troubleshooting section) Your PAW is now ready for operation.
Only charge your PAW batteries in an open, dry, well
-
ventilated area.
ONLY
use the charger supplied with
your PAW. Use of other charging systems could damage the unit and may cause harm to you.
If your indicator light does not change to green within 24 hours, call us at 1
-
800
-
495
-
9278 or visit us online
at my
-
paw.com. The charger has a built in safety switch that prevents overcharging of the batteries.
To purchase replacement batteries or charger contact customer service at 1
-
800
-
495
-
9278
48.
Your Paw comes with partially charged batteries, (normally 60 to 70%) And it should operate normally once
assembled. However, it is a good idea (although not necessary) to bring your batteries up to a full charge before
operating. See page 5 for battery information.
49.
Connect the battery charger as shown on page 17. When the indicator light turns from red to green on the charger
the PAW is ready for operation. The amount of time needed full charge the batteries will vary from ½ hour to up to
12 hours.
50.
Once battery is charged unplug the charger and reinstall the power plug by reversing all previous steps in the
“attaching the battery charger” section on page 17.
51.
Once you have become comfortable maneuvering the PAW with power OFF and the batteries are fully charged, it is
time to turn the power ON.
No lights =
No
charge available
because power
switch off or
power plug is
not installed.
Empty light =
Battery at lowest
charge and should
be recharged soon
for best operation.
Full light =
Full charge
battery is at
full charge and
ready for
operation.
Forward Reverse Button:
The red forward and reverse button is located on the right handle control module. Pushing
this red button will change the direction of forward or reverse.
Reverse:
In the reverse position the PAW is designed to achieve a walk speed. This low walking
speed is designed for safety reasons. Take
CAUTION
when the PAW is in reverse with both
hands on the handles and solid footing.
Forward:
The forward position has a built in additional power boost when throttle is pushed down fully.
At full throttle the PAW will move forward at a very fast walk speed. Take special care when
using full throttle. The use of power boost is designed for use when climbing hills with the
tray loaded.
Throttle
Indicator Lights
Forward/Reverse
PAW Controls
Indicator Lights
Indicator Lights
Power Switch
Charging the batteries
Operating your PAW