GETTING STARTED
The unit arrives with the stand mount tucked under the unit. To release, open the locking handle by pulling
out and loosening the large knob by turning counter-clockwise. The stand mount will then move freely.
Place the open collar at the base of the stand mount over the stud mount on your light stand.
Tighten the small knob, by turning clockwise, to secure. Tighten the large knob, by turning clockwise,
while holding the locking handle with your flash unit at your desired angle. Once satisfied with its
placement, push the locking handle in towards the stud mount to secure. To readjust the tilt, simply pull
the handle outwards from the stand mount, reposition your flash unit, and then push the locking handle
in towards the stud mount to secure the placement. Make sure that the unit is secure prior to releasing.
STAND MOUNT
The stand mount is made of aluminum and features a locking handle, and two knobs.
The
smaller knob
is what attaches the stand mount to the stud of your light stand.
The
larger knob
connects directly to the
locking handle
and allows you to control and secure
the tilt position of the flash unit.
SMALL KNOB
LARGE KNOB
LOCKING HANDLE
The shipping cover is made of aluminum and
provides protection to the flash tube when
transporting or storing your flash unit.
You MUST remove the shipping cover prior
to turning on the flash unit.
REMOVE THE SHIPPING COVER
To remove the shipping cover, slide either
of the quick-release levers to retract the
four faceplate fingers holding the cover.
QUICK-RELEASE
LEVER
SHIPPING COVER
PLACING THE LINK ON A LIGHT STAND
SHIPPING COVER
4
