Paul Agnew Ilektro 1250L, User Instructions And Installation, Page: 18 / 40

18
POSITIONING YOUR APPLIANCE
• YOUR NEW APPLIANCE MAY BE INSTALLED
VIRTUALLY ANYWHERE IN YOUR
HOME. HOWEVER, WHEN CHOOSING A
LOCATION ENSURE THAT THE GENERAL
INSTRUCTIONS ARE FOLLOWED.
• THE POSITIONING OF THE APPLIANCE
SHOULD IDEALLY BE FITTED INTO/
ONTO A FLAT WALL OF BLOCK/BRICK
CONSTRUCTION OR AN INTERNAL
WOODEN FRAME PLASTER BOARD
WALL. NO FIXINGS ARE PROVIDED WITH
YOUR APPLIANCE. PLEASE SEEK ADVICE
FROM YOUR RETAILER REGARDING
FIXING METHODS, BASED ON YOUR
CHOSEN INSTALLATION POSITION AND
YOUR WALL MATERIAL.
• ALWAYS ENSURE THE APPLIANCE IS
ADEQUATELY SUPPORTED AND SITS ON
A FIRM STRUCTURE WHEN MOUNTING
ABOVE FLOOR LEVEL.
• IF THE POWER CORD IS DAMAGED, IT MUST
BE REPAIRED BY THE MANUFACTURER,
ITS AUTHORIZED SERVICE CENTRE OR
PROFESSIONAL PERSON.
• ENSURE THAT CURTAINS AND FURNITURE
ARE NOT POSITIONED CLOSE TO THE
CHOSEN POSITION, AS THIS WOULD
CREATE A POTENTIAL FIRE HAZARD OR
BLOCK THE HEATER OUTLET DUCTS. FOR
BEST RESULTS, INSTALL OUT OF DIRECT
SUNLIGHT.
• THE APPLIANCE SHOULD IDEALLY BE
LOCATED CLOSE TO A SUITABLE MAINS
SOCKET TO ENABLE CONNECTION. THE
ELECTRICAL SOCKET MUST BE EASILY
ACCESSIBLE TO ALLOW DISCONNECTION
WHEN THE APPLIANCE IS FITTED.
• WARNING! IF THE ELECTRICAL SOCKET IS
NOT ACCESSIBLE ONCE THE APPLIANCE
HAS BEEN INSTALLED THEN A
QUALIFIED ELECTRICIAN WILL NEED TO
INSTALL AN ISOLATION SWITCH.
• WARNING! KEEP ANY FURNISHINGS OR
COMBUSTIBLE MATERIALS AT LEAST 1m
FROM THE FRONT OF THE ELECTRIC
FIREPLACE.
HOW TO INSTALL YOUR
APPLIANCE
9
. INSTALLATION