Patty-O-Matic Protege, Owner'S Manual

Page: 10 / 26

10
- Remove Knock Out Cup by
loosening the Knock Out Knob
while holding the other end of the
bolt with the speed driver.
Knock Out
Knob
Knock Out
Cup
Speed Driver
- All of the parts that were removed from
the machine can now be washed and
sanitized thoroughly. The cleaning
solution should be 50 parts per million
chlorine, but no more than 200 parts per
million. The machine itself should be
cleaned and sanitized by hand using a cloth
or sponge.
This Machine Should Not Be Hosed Down
or Pressure Washed For Cleaning!
*To Re-Assemble the Machine reverse the above procedure.
Hopper Bolts should only be hand-tightened with the tool
provided.
*The Knock Out Cup should be installed on the machine after all
other parts are in place. The Mold Plate should be all the way
forward and the Knock Out Arm should be in the down position
for the cup to align properly with the mold plate.
Installing Patty Paper on the Interleaver
Place a stack of paper no thicker than one
inch under the Pressure Foot. Slide hole
in the stack of paper over the center pin
on the interleaver. This can be
accomplished with out stopping the
machine.
*Placing more than one inch of paper
on the pin may cause improper feeding.
Center Pin
Patty-O-Matic Inc. offers the highest quality
patty paper, machine lubricant, and machine
grease. Please contact the factory for
information on these products.
Toll Free in the U.S.A. 877-938-5244
Outside the U.S.A. 732-938-2757
Pressure Foot