2
The 32 port Patton requires the following connection cable, which must be ordered separately:
Patton connection cable 64 PIN TELCO to open end
Connection cables are not included in the standard delivery of Patton devices and must
be ordered separately!
NFON auto-provisioning only works with Patton devices purchased from NFON. NFON installs the
respective firmware onto the devices to support this function.
Multiport Patton devices are billed per activated port at device prices. You can activate and
deactivate the desired number of ports via the service site. Only enabled/activated ports are billed.
Please also note that there are specific network requirements, to ensure the smooth
communication with the nfon telephone system.For more information on network
requirements/configuration, please refer to the “
”.
Many multifunction devices and modern fax devices are capable of various settings for specific
transmission standards that might disturb the adapter. Trying to send a fax, the device will give an
error message which varies depending on the device model and producer.
Note that a fax number dialed needs an prefix number (e.g. 9 for UK).
Furthermore, deactivate the following settings:
Deactivate V.34
Set the maximum bit rate to 9600 bps (alternatively marked as 9.6k)
Deactivate the function "Use on extension.
Decativate automatic telephone ringtone
Deactivate automatic prefix number
Enable port range 4000-4999 in your firewall
Check in the manual of your fax device, if the above mentioned settings are applicable for your fax
and how to configure the settings. In case of doubt, ask the producer directly. Many manufacturers
provide the configuration details on their website in the FAQ or Troubleshooting section. Pay
attention to any note concerning sending faxes via VoIP.
It is fundamentally necessary to set the maximum bitrate to 9600 in the administration
portal!
B. Initial operation