Installing the rack ears
69
SmartNode 5540E & 4140E Series User Manual
G
• Installing Optional Rack Ears
Installing the rack ears
Do the following:
1.
While holding the rack ear in place where shown in
, use a cross-tip screwdriver to install three
mounting screws (included with the rack ears kit) to secure the rack ear.
2.
Repeat step 1 to install the remaining rack ear on the other side of the device.
Figure 25. Connecting the 552-GS2 to a CL1300R
3.
Install the device in a 9-inch rack
using mounting screws (not supplied).
Congratulations! The rack ears are installed.
If you have a DIN rail mounting clip to install, go to Appendix H,
“Installing Optional DIN Rail Mounting
on page 70. Otherwise, go to section
Summary of Contents for SmartNode 5540E Series
Page 54: ...54 Appendix C Cabling Chapter contents Introduction 55 Ethernet 55 Analog FXS 56 Analog FXO 57...
Page 61: ...61 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 62...
Page 68: ...68 Appendix G Installing Optional Rack Ears Chapter contents Installing the rack ears 69...