Connect with Web GUI
38
CopperLink Model CL1300MDE User Manual
5
• Wizard Interface
User Access: (optional configuration)
Users may change the password for the admin user.
•
Management IP Setup
:
-
Static
: Create your own IP address, netmask and gateway (optional–the gateway is required for remote
management).
-
DHCP
: The CL1314MDE management port will accept an IP address from a DHCP server.
-
Both
: This choice will assign two IP addresses (one static and one DHCP to the management port
-
Management VLAN ID
: (Optional) define a VLAN ID for management traffic.
•
Line Setup
: This where you can manually set your CopperLink line options.
Note
The CopperLink Ethernet Extenders by default are set to plug-and-play
operation.
-
Line Type (Local or Remote)
: This will set the Ethernet Extender as Local or Remote. Local is typically
used at the network, Remote is typically used at the remote device or remote network. Your CopperLink
CL1300MDE is already configured with port C1 as Remote and C2 as Local.
-
Service Mode
: Configures the number of pairs (wires) you want to use. The CL1300MDE will default to
the maximum number of wires available on your version of the CopperLink. CL1314MDE (2-wire) or
CL1324MDE (4-wire).
-
Annex
: Consult technical support before changing this setting.
-
Line Rate Configuration
: This will increase the potential line rate of the CL1300MDE. Your Copper-
Link 1300 is defaulted to automatically select the optimal rate based on the distance (adaptive).
Note
There are two modes: Normal (TCPAM16|32) and Extended
(TCPAM64|128). Selecting the Extended mode will double the bandwidth,
but will reduce the reach (distance) in half. Default is normal mode
(TCPAM16|32).
Click the
Preview
button located on the bottom right corner of the CL1300MDE Basic Configuration wizard
page to preview configurations and reboot.
on page 39 depicts is what you can expect to see if you
click on the Preview tab.
