1
2
TABLE OF CONTENTS
SECTION
PAGE
1.0 Warranty Information .............................................................2
1.1 Radio and TV Interference
1.2 Service Information
2.0 General Information ...............................................................4
2.1 Product Features
2.2 General Product Description
3.0 Configuration .........................................................................5
3.1 Configuring the IM2RC/F-128K Hardware Switches
3.2 Connecting the Interface Driver Board
4.0 Installation .............................................................................9
4.1 The Model 1000R16 Rack Chassis
4.1.1 The Rack Power Supply
4.2 Installing the Rear IM2RC/F-128K Card and Front Function
Card
4.3 Making Interface Connections
4.3.1 Connecting to a G.703 PCM Network Channel
4.3.2 Connecting the Line Interface
4.3.3 Two-Wire and Four-Wire Cable Connection via RJ-45
5.0 Operation .............................................................................14
5.1 Typical Application
5.2 Operating Instructions
Appendix A - Specifications........................................................15
Appendix B - Cable Recommendations......................................16
Appendix C - Factory Replacement Parts ..................................17
Appendix D - 120 Ohm G.703 Interface Pin Assignment...........18
Appendix E - Line Interface Assignment ....................................19
1.0 WARRANTY INFORMATION
Patton Electronics warrants all Model IM2RC/F-128K compo-
nents to be free from defects, and will—at our option—repair or replace
the product should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials,
and does not cover customer damage, abuse or unauthorized modifi-
cation. If this product fails or does not perform as warranted, your sole
recourse shall be repair or replacement as described above. Under no
condition shall Patton Electronics be liable for any damages incurred
by the use of this product. These damages include, but are not limited
to, the following: lost profits, lost savings and incidental or consequen-
tial damages arising from the use of or inability to use this product.
Patton Electronics specifically disclaims all other warranties,
expressed or implied, and the installation or use of this product shall be
deemed an acceptance of these terms by the user.
1.1 RADIO AND TV INTERFERENCE
The Model IM2RC/F-128K generates and uses radio frequency
energy, and if not installed and used properly—that is, in strict accor-
dance with the manufacturer's instructions—may cause interference to
radio and television reception. The Model IM2RC/F-128K has been
tested and found to comply with the limits for a Class A computing
device in accordance with the specifications in Subpart J of Part 15 of
FCC rules, which are designed to provide reasonable protection from
such interference in a commercial installation. However, there is no
guarantee that interference will not occur in a particular installation. If
the Model IM2RC/F-128K does cause interference to radio or television
reception, which can be determined by disconnecting the unit, the user
is encouraged to try to correct the interference by one or more of the
following measures: moving the computing equipment away from the
receiver, re-orienting the receiving antenna and/or plugging the receiv-
ing equipment into a different AC outlet (such that the computing
equipment and receiver are on different branches). In the event the
user detects intermittent or continuous product malfunction due to
nearby high power transmitting radio frequency equipment, the user is
strongly advised to use only data cables with an external outer shield
bonded to a metal or metalized connector at both ends. Shielded
cables must be used on the network connection to satisfy compliance
with the Electromagnetic Compatibility (EMC) directive.
