Patton electronics Access Server, Administrator'S Reference Manual

Page: 186 / 262

18 • RIP Version 2 Access Server Administrators’ Reference Guide
186 Introduction
Introduction
The RIP Version 2 main window (see figure 59) describes routing information as defined by the Routing Infor-
mation Protocol (RIP). All object identifiers described in this chapter comply with those contained in RFC
1724: RIP Version 2 MIB Extension.
Figure 59. RIP Version 2 window
Click on
RIP Version 2
under the
Configuration Menu
to to display the RIP Version 2 main window.
RIP Version 2 main window
The RIP Version 2 window describes routing information as defined by the Routing Information Protocol
(RIP). The window also contains the following links:
• Statistics—Clicking on this link displays the RIP Version 2 Configuration window (see “RIP Version 2—
Configuration” on page 187). This window is where you can configure objects for each subnet address
including authentication method, RIP Version 1 or Version 2 compatibility, and metric value.
• Address (xxx.xx.xxx.xxx)—Clicking on the link under the Address column displays the RIP Version 2 Status
window (see “RIP Version 2 (Statistics)” on page 189) where you can view routing and update information
for each subnet address
Route Changes Made (rip2GlobalRouteChanges)
The number of route changes made to the IP Route Database by RIP. This does not include the refresh of a
route's age.
Responses Sent (rip2GlobalQueries)
The number of responses sent to RIP queries from other systems.
Adding a RIP address
Do the following:
1. Enter the IP network address of the interface on the access server that you want to enable RIP. This is not
the IP address of the device you want to direct RIP packets to.