APPENDIX A
PATTON MODEL 2017A SPECIFICATIONS
Transmission Line:
19 to 26 AWG twisted pair
Range:
4 miles on 24 AWG twisted pair
Interfaces:
Asynchronous, EIA RS-232, CCITT V.24 full
duplex, 20mA current loop
Data Rates:
DC to 115,200 bps
Isolation:
1500V RMS via opto-isolators
Connectors:
DB-25 male or female on RS-232; RJ-11,
RJ-45 or terminal posts with strain relief for
current loop side
Operation:
Transmitter is always active; receiver can
be configured as active or passive with a
switch
Power Supply:
9V DC at 500mA; option of either 110V AC
or 220V AC; 60Hz
Temperature Range:
0-60°C (32-140°F)
Altitude:
0-15,000 feet (0-5,000 meters)
Humidity:
5 to 95% noncondensing
Dimensions:
2.66" x 2.10" x .73"
Weight:
1.5 oz.
4.1.2
TWISTED PAIR CONNECTION USING MODULAR JACKS
The modular version of the Model 2017A has an RJ-11 or RJ-45
jack mounted in the case. These jacks are prewired for a standard
TELCO wiring environment. To be sure you have the right wiring, use
the table below as a guide.
RJ-11
SIGNAL
RJ-45
SIGNAL
1----------------GND*
1----------N/C
2----------------RCV-
2----------GND
3----------------XMT+
3----------RCV-
4----------------XMT-
4----------XMT+
5----------------RCV+
5----------XMT-
6----------------GND
6----------RCV+
7----------GND
8----------N/C
*Connection to ground is optional
NOTE: AT&T standard modular color codes are as follows:
4.2. COMPLETING THE INSTALLATION
Once you have configured the unit for DTE or DCE and connected
the twisted pair wires correctly, simply plug the Model 2017A into the
RS-232 data port. Remember to insert and tighten the two captive
connector screws.
The Model 2017A requires 9 volts of DC power (with a trans-
former, it will work with either 110V or 220V). To order the power sup-
ply, call Patton Electronics Customer Service at (301) 975-1000.
9
10
1 - Blue
2 - Yellow
3 - Green
4 - Red
5 - Black
6 - White
1 - Blue
2 - Orange
3 - Black
4 - Red
5 - Green
6 - Yellow
7 - Brown
8 - Slate
