GB
- 298 -
solvents or water to remove dirt.
•
The blade is subjected to more wear and tear than any other com-
ponent. Therefore, routinely check the condition of the blade and
make sure that it is tightly fastened. If the blade is completely worn
out, it must be immediately replaced or ground sharp again. An
excessively vibrating mower means that the blade is not properly
balanced or has become deformed from striking an object. In this
case, the blade must be repaired or replaced.
•
There are no parts inside the equipment which require additional
maintenance.
Replacing the blade
For safety reasons, we recommend having the blade replaced by an
authorized professional. Important! Wear work gloves! Only replace
the blade with a genuine Einhell replacement blade, as this will ensu-
re top performance and safety under all conditions.
Spare blade: 34.054.85
Carry out the following steps to change the blade:
1. Undo the fastening screw (see Fig. 18).
2. Remove the blade and replace with a new one.
3. When
fi
tting the blade, make sure it is installed in the right direc-
tion. The blade‘s air vanes must project into the motor compart-
ment (see Fig. 18). The dome mounts must be aligned with the
punch holes in the blade.
4. Then retighten the fastening screw with the universal wrench. The
tightening torque should be approx. 25 Nm.
At the end of the season, perform a general inspection of the lawn
mower and remove any grass and dirt which may have accumulated.
At the start of each season, ensure that you check the condition of
the blade. If repairs are necessary, please contact our customer ser-
vice center. Use only genuine spare parts.
Anl_PE_ARM_36_Li_SPK7.indb 298
Anl_PE_ARM_36_Li_SPK7.indb 298
07.12.15 13:37
07.12.15 13:37
