EN
104
Product overview
AUXILIARY HANDLE
The auxiliary handle can be attached
to the auxiliary handle connector
9
on
either side of the tool.
Caution!
Make sure the tool is
switched off and unplugged.
1
Screw the auxiliary handle into the
auxiliary handle connector
9
.
For safe working conditions, make
sure the auxiliary handle is always
mounted to the tool.
2
Cutting:
Caution!
Only use cutting
wheels (thickness 2 - 4 mm) for
cutting.
When cutting, do not press, tilt or oscil-
late the tool. Gently slide it forward with
a speed adapted to the material being
worked on.
The tool must always work opposite to
the direction of rotation, otherwise there
is danger of being pushed out of the cut in
an uncontrolled way.
4.
To switch off the tool, release the on / off
switch
5
.
Using the tool
1.
Make sure your workpiece can not slip
and hold the tool firmly at the main han-
dle
3
.
2.
To switch on the tool, push safety lever
6
forward and press the on / off switch
5
.
3.
Let the tool run at no-load speed for about
a minute and check if the installed wheel
runs flawlessly.
Grinding:
Caution!
Only use grinding
wheels (thickness 6 - 8 mm) for
grinding.
The best grinding results can be achieved
with a 30° to 40° approach angle. Move
the tool back and forth with moderate
pressure.
1
Grinding guard
2
Cutting guard
3
Main handle
4
Power cord
5
On / Off switch
6
Safety lever
7
Inner flange
8
Outer flange
9
Auxiliary handle connector
10
Spindle lock button
