EN
88
noise & Vibration
The values given in these instructions have
been measured in accordance with a stand-
ardized measurement procedure specified in
EN 60745 and can be used to compare tools.
It may be used for a preliminary assessment
of exposure.
Battery information
The battery is supplied partially charged. Com-
pletely charge the battery before using the tool
for the first time. The lithium ion battery can
be charged at any time without reducing its
service life. Interrupting the charging proce-
dure does not damage the battery.
The battery is protected against deep dis-
charging by the “Electronic Cell Protection
(ECP)”. When the battery is empty, the tool is
switched off by means of a protective circuit.
Therefore do not press the on / off switch
4
after the machine has switched off automati-
cally. The battery can be damaged.
Due to the NTC temperature control, the bat-
tery can only be charged at temperatures be-
tween 0 °C and 50 °C.
If the temperature exceeds 70 °C during op-
eration the tool is switched off by means of
a protective circuit. Once the temperature is
between -10 °C and 70 °C, the tool can be
operated normally.
warning!
The vibration emission
during actual use can differ from the
declared total value depending on the use
of the tool.
technical Data
nominal voltage
10.8 V
chuck size
0,8-10 mm
no load speed range
1
st
Gear
0-350/min
2
nd
Gear 0-1200/min
max. torque
15 Nm (ISO 5393)
max. screw diameter
8 mm
max. drilling capacity
Steel
10 mm
Wood
30 mm
torque setting
15 + drill
Sound pressure level (L
pA
)
< 70 dB(A)
max. vibration emission (a
h
)
< 2.5 m/s
2
Battery capacity
1500 mAh
Battery charger input
220-240 V ~ / 50/60 Hz / 56 W
Battery charger output
12 V /3 A
charging time
0.5 hours
