−
the attendants hands must be inside the handle straps at all time
−
take rests in regular intervals
−
do not lift the buggy with footrest
going down steps
- position the buggy squarely with the front wheels on the top step, tilt the handle
backward and push the buggy forward until the rear wheels are at the top step; the helper stands in front,
steadies and lowers the buggy by gripping the front frame; take the weight and lower the rear wheels down
the step, continue step by step to the bottom. (picture no. 1)
going up steps
- position the buggy squarely with the rear wheels against the bottom step, tilt the buggy
backward and raise to the next step, the helper stands in front, steadies and lifts the buggy by gripping the
front frame, continue step by step to the top (picture no. 2)
Folding the buggy:
unfasten the dry zipper of armrest upholstery, unlock rear brace by pushing up on centre of brace. (Unlock
the seat brace - size 38) Grasp one handle and pull up the seat tube with other hand. Lock the storage clip.
Is not necessary to uninstall the footrest for folding the buggy. (Picture no.3)
Upholstery:
the seat, seat reinforcement, backrest and backrest extension are not detachable. You could clean them by
warm water and mild detergent.
Armrests:
undo the velcro and button to uninstall the armrests upholsteries.
Wash by hands on max. 40°C with mild detergent.
Seat reinforcement:
you could increase or decrease the seat rigidity by adjustment of the seat reinforcement. Lengthen the belts
of seat reinforcement to decrease the rigidity. Shorten the belts of seat reinforcement to increase the
rigidity. Never change the seat width by adjusting of the seat rigidity.
4
pic.1
pic.2
pic.3
5
MAINTENANCE INSTRUCTION
−
your buggy has been designed to a high standard and with correct use and maintenance will give many
years of trouble free service
−
regularly inspect locking devices, catches, footrest, joints fixings to ensure they are secure and in full
working order
−
brakes, wheels, tires are subjects to wear and should be replaced if necessary by a repairer approved by
the buggy supplier
−
we recommend that the buggy is checked by an approved repairer every 12 month.
−
if the buggy is damaged or in need of repair, the approved repairer will be able to advise on what is
required.
−
alternatively, PATRON Bohemia s. r. o. Customer department is available for product information.
−
only PATRON Bohemia s. r. o. replacement parts should be used on this buggy.
−
should parts of your buggy become stiff or difficult to operate )or not
later than every 6 month),
ensure that dirt is not the cause, apply a light application of a spray lubricant e. g. WD 40 (do not use
oil or grease). Ensure that the lubricant penetrates between the components but do not over spray as
this may encourage the accumulation of dirt. Wipe off any access spray. Regular lubrication of moving
parts will extend the life of your buggy and take opening and folding easier.
−
make sure that you are familiar with the operation of the buggy. It should always open and fold easily.
If it does not, do not force the mechanism - stop and read the instructions.
−
wheels, plastic and metal parts may be sponged clean with warm water and mild detergent.
−
the seat fabric can be washed by hands (max. 30°C).
−
never clean with abrasive, ammonia based, bleach based or spirit type
cleaners.
−
after exposure to damp conditions, dry off with a soft cloth and leave
fully open in warm
environment.
−
store your buggy in a dry, safe place.
PATRON Bohemia s. r. o. reserves the right to make design changes to any of their products without prior
notice as a part of their continuous development program.
