CARE, MAINTENANCE AND STORAGE
Warning! Risk of injury! Before performing any operation unplug the power cord from the
wall socket.
Warning: Other maintenance and repair work than those listed in this manual, must only be
performed by an authorized manufacturer's service. When the cable is damaged it may only
be replaced by
an authorized manufacturer’s
service. Safety and operational reliability can
only be guaranteed when using original spare parts.
The power tool is almost maintenance
-
free
•
Keep the power tool and the air vents clean
and unplugged.
•
Make sure that no moisture
reaches the inside of the power tool during cleaning
.
•
Service repair consists of replacing worn carbon brushes only (contact your seller or a qualified
electrician)
.
Cleaning
•
Clean the power tool after every use. Remove dust, shavings, wood splinters, etc
.
•
Clean the power tool with a wet cloth. Do not use cleaning agents or solutions; these can corrode the
plastic parts of the power tool.
Storage
•
Keep the tool in a dry and safe place.
TR
OUBLESHOOTING
Problem
Possible cause
Solution
Circular saw does not work
Mains socket is not live
Check mains socket and/or
circuit breaker/RCD
Power cable fault
Check whether
power cable is
disconnected or damaged
Unclean cut
Blunt saw blade
Replace saw blade
Saw blade is loose or
not
clamped properly
Check and re
-
fit the
saw blade
properly
Base plate loose
Check and re
-
tighten screw of
the base plate
Motor overheated
Overload due to excessive
pressure to cut
Allow the motor to cool down
by running the tool idle for
3
minutes
34
