ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
C
Page 4 of 7
200810
Sensor Adjustment Lower For Short Coverage
Sensor Adjustment Higher For Long Coverage
Fig. 5
Fig. 4
Fig. 2
Fig. 3
Adjusting the Light Head:
2.
Keep the light heads (D) 30˚ below horizontal to avoid water d
amage and electrical shock.
Sensitivity of Motion Sensor
● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right
side of the bottom surface of the sensor. (See Fig. 4)
● Adjust motion sensor sensitivity to achieve desired performance.
● Approximate range for each setting from 10ft to 70ft.
Choose a mode by sliding the switch on the bottom of the sensor of the fixture. (See Fig.4 )
Note: When power is first applied, the light will turn on immediately. Wait for 30 seconds to allow the sensor
to warm up.
1. TEST MODE (daytime and nighttime operation.)
● Rotate knob on the bottom of the sensor to the “TEST” position. (See Fig.4 )
Adjusting the Sensor Head (C):
1. Aim sensor head (C) toward desired detection area, maintaining a
5° - 40° downward angle to allow moisture to drain.
Note: Make sure sensor head (C) is positioned with controls facing
toward the ground.
2. You can move the sensor head (C) up and down to change the
coverage area. (See Fig. 1)
Note: Range set too high may increase false triggering.
(See Fig. 2 and Fig. 3 )
Fig. 1
1.Gently grasp the light heads (D) and tilt them left or right to adjust the light coverage area. Keep the light heads (D) at
least 1” (25mm) away from the sensor.(See Fig. 5)
D
D2D
OFF
3MIN
5S
TEST
TIME
SENSITIVITY
LOW LEVEL
+
-
3H
6H
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
FUNCTION AND OPERATION (continued)
