ASSEMBLY INSTRUCTIONS (continued)
Installation Steps
1.Install the mounting strap (BB)
to the outlet box with the
stamped word “FRONT” facing
away from the outlet box,
using two mounting screws
(AA) that best fit the outlet box.
Back plate should sit flush
against wall surface when
secured. (Choose one
matching pair of suitable
mounting screws (AA) from
the 3 pairs provided)
Outlet Box
2. Fixture wires thread through
gasket (FF), then attach the
gasket (FF) into backplate (A).
3. Pull out the source wires from
the outlet box. Make wire
connections using wire
connectors (EE) as follows:
---Connect the black wire from
the fixture to the “hot” wire
from the power source.
(usually black)
---Connect the white wire from
the fixture to the neutral wire
from the power source (usually white).
---Connect the grounding wire from the fixture to the
grounding wire from the power source (usually
green / yellow insulation).
Carefully tuck the wires back into the outlet box.
A
C
C
5. Align the three slots in the
decorative shell (B) with the
light head stoppers. Push the
shell (B) in and then twist
clockwise to lock. Repeat for
the other shell (B).
6. Install bulbs (not included).
See relamping label at
socket area or packaging
for maximum wattage
allowed.
Before installing the light fixture under an eave, the sensor head must be rotated as shown in the next two steps for
proper operation and to avoid the risk of electrical shock.
For eave mounted only:
Rotate the sensor head (C) towards the backplate (A).
.
Rotate the sensor head (C) clockwise 180˚ so the controls face
down.
1
BB
AA
A
2
FF
4. Attach the backplate (A) of
the fixture to the mounting
strap (BB), secure it with the
fixture mounting screw (DD).
Push the decorative cover
(CC) firmly into the fixture
mounting screw (DD) hole
on the light.
Controls
Controls
Controls
A
4
BB
CC
DD
Max.150W PAR 38 Bulb
(not included)
6
B
Slot
Stopper
5
D2D
OF
F
3M
IN
5S
TES
T
TIM
E
SENSI
TIV
ITY
LOW
LEV
EL
+
-
3H
6H
7
7. With silicone caulking compound (not included), caulk completely around where the
backplate (A) of the fixture meets the wall surface.
CAUTION: Be sure to caulk completely where the backplate meets the
wall surface to prevent water from seeping into the light fixture and /or
outlet box.
A
Page 3 of 7
200810
A
Outlet Box
EE
3