1. DISCONNECT POWER AT THE CIRCUIT BREAKER.
2. Thread the FIXTURE SCREWS into the holes at the end of the MOUNTING BRACKET.
Thread a HEX NUT onto the each FIXTURE SCREW. Do not tighten the HEX NUT at
this time. (FIG. 1)
3. Pull the power supply wires out from the OUTLET BOX, and attach the MOUNTING
BRACKET to the OUTLET BOX, using the BRACKET MOUNTING SCREWS. (FIG. 1)
4. Strip approximately
¼” of insulation from each supply wire from the OUTLET BOX.
Raise the main fixture body to the wall, bringing the WALL PLATE close to the OUTLET
BOX. Make the following wire connections using the WIRE NUTS (FIG. 1):
WHITE (NEUTRAL) SUPPLY WRE
to
WHITE FIXTURE WIRE
BLACK (HOT) SUPPLY WIRE
to
BLACK FIXTURE WIRE
SUPPLY GROUND WIRE
to
FIXTURE GROUND WIRE
Wrap each wire connection with 2
” of electrical tape.
5. Place the WALL PLATE over the OUTLET BOX, making sure the FIXTURE SCREWS
feeds through the hole of the WALL PLATE.
Adjust the FIXTURE SCREWS until it
protrudes out from the WALL PLATE
¼”. Remove the WALL PLATE and secure the
position of the FIXTURE SCREWS by tightening the HEX NUT against the MOUNTING
BRACKET. (FIG. 1)
6. Carefully tuck all WIRES and WIRE NUTS into the OUTLET BOX. Place the WALL
PLATE back onto the FIXTURE SCREWS, and secure it into place using the LOCK
NUTS. (FIG. 1)
ASSEMBLY AND INSTALLATION:
CAUTION:
• All electrical connections must be in accordance with local and National Electrical Code
(N.E.C.) standards. If you are unfamiliar with proper electrical practices, obtain services
of a qualified electrician.
• Turn off the main power at circuit breaker before installing fixture, in order to prevent
possible shock.
• Before cleaning fixture, turn off power and allow several minutes for the fixture to cool
down.
BEFORE YOU BEGIN:
Page 4
• The OUTLET BOX described in the following section is not provided. To install this
fixture, a standard OUTLET BOX needs to be pre-installed at the selected mounting
location. Power supply wires need to be run into the OUTLET BOX, extending
approximately 6
” from its opening. If an OUTLET BOX does not exist, contact a
qualified electrician to have one installed.