background image

Black (hot/power)

White (neutral)

Bare/Green

(ground)

Whit

e

Red

Black

Blac

k

Whit

e

Blue

Blue

White

Gree

n

Gree

n

Receiver

1.  Use existing pull chains on the desired 

fan to set fan speed to HIGH and to turn 

the light ON.

2.  Turn off circuit breakers and wall switch 

to the fan.

 

 

DANGER: 

Failure to disconnect 

power supply prior to installation may 

result in serious injury or death.

3.  Lower the canopy of the previously 

assembled fan and insert receiver.

Note:

  If installing this product with 

a new fan, insert the receiver in the 

mounting bracket before wiring the 

fan; wire the fan according to these 

instructions, then continue fan assembly 

as directed in the fan’s instruction 

manual.

PREMIUM

REMOTE CONTROL

Model #20704 (363-5811)

4.  Disconnect existing wire connections, 

then secure all wire connections with 

wire connectors according to diagram 

and these steps:

•  Connect the Blue wire with white label 

from the receiver to the Blue fan wire. 

•  Connect the Black wire with white 

label from the receiver to the Black fan 

wire. 

•  Connect the White wire with white label 

from the receiver to the White fan wire.

•  Connect the Red wire with red label 

from the receiver  to the Black (hot/

power) supply wire.

•  Connect the White wire with red 

label from the receiver to the White 

(neutral) supply wire.

Fan Pull 

Chain

Light Pull 

Chain

Canopy

High

LED Indicator

Wall Bracket

Mounting

Screw

5.  Wrap electrical tape (not included) 

around each wire connector down to 

the wire. Then, push wire connections 

into the outlet box. Place the White wire 

connections on the opposite side of the 

outlet box from the Black and Blue wire 

connections. 

6.  Reinstall the canopy.

7.  Turn on power supply and wall switch to 

the fan.

8.  Remove the battery cover from the back 

of the remote and install the A23 12-

volt battery. Replace the battery cover 

and press the HIGH button to ensure 

the LED indicator illuminates and the 

fan turns on.

9.  If desired, the wall bracket can be 

attached to a wall using the mounting 

screws. 

Questions? 

Call our customer service department at 

1-877-459-3267, 9 a.m. - 5 p.m. Central Time. 

Remote

Qty. 1

Wall Bracket

Qty. 1

Battery

Qty. 1

Receiver

Qty. 1

Wire Connector

Qty. 5

Mounting Screw

Qty. 2

Owner’s Manual

Qty. 1

Read instructions completely before installing the remote.

 WARNING: 

If the color of the household supply wires is different than what is referred to in the instructions below, a professional electrician should determine proper wiring.

CAUTION:

• Do not install in damp locations. For indoor use only.

• Do not use with fans that have integrated remote controls.

• Be sure the outlet box is properly grounded or that a green or bare (ground) wire is present.

• This unit is intended to control a ceiling fan with electrical source of AC 110/120V, 60Hz.

• To reduce the risk of fire or electric shock, do NOT use a full-range dimmer switch to control the fan speed.

• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the grantee of this device could void the user’s 

authority to operate the equipment. tt

HKC-US

3350 Players Club Pkwy. #225, Memphis, TN 38125 

(877)459-3267

®

 

Owner’s

Manual

SAFETY INSTRUCTIONS

SAFETY INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

1

5

2

6

3

7

4

8

9

Warning: 

Never wire fan to 

a wall control. Only wire to a 

single-pole on/off wall switch. 

Canopy

Reviews: