Pair the Remote and the Receiver Collar
1. Press the Dog 1 button of the remote .
2. Make sure the receiver collar is turned off, Press and hold the ON/OFF
button on the collar for 4-5 seconds.
3. The receiver red & green LEDs will blink for about 15 seconds, which
indicates that it is ready for adding and then release the button.
4. Press the remote tone and vibration buttons at the same time and hold
for 2-3 seconds. The LED on the receiver collar will blink for 5 times,
which indicates successful pairing.
Pair the Second Collar with the Remote
If the remote only is dog 1 mode, you need to unlock the dog 2 mode:
Press "DOG 2" and "-" key at same time and hold 5 second.
（
Repeat this
operation to lock DOG 2 again
）
Press the Dog 2 button of the Remote to select Dog 2. Then follow the above
pairing steps from 2-4.
Collar Fitting
Please fit the collar properly, ensuring that the contact points press firmly against
the dog's skin. When properly fitted, you should be able to put a finger in between
the receiver collar and dog’s neck.
11
