29 | P a g e
PATON
®
PSI STANDARD SERIES DC MIG/MAG TIG/MMA
ATTENTION!
The output voltage of the electric generator must in the range of
160 … 260 V in the single phase. This also applies to three-phase devices, in the
situation of three-phase power supply ±15 %. The manufacturer suggest the use of
a generator set with the AVR system responsible for voltage stabilization.
10. STORAGE
The preserved and packed welding unit can be stored according to State Norm
for 5 years.
The welding
unit should be stored in a dry closed room at an ambient temperature not lower than 5ºC. In the room,
acid vapors and chemically active substances must not be present.
11. TRANSPORTATION
The packed welding unit can be transported by any means of transport, which ensure the integrity of the
unit and compliance of the unit with the shipping rules established for the specified transport means.
12. SPECIFICATION DATA
ATTENTION!
If the welding unit is rated for a special power supply voltage,
the specification data of the unit are indicated on the nameplate on the rear panel
of the unit. In this case, the electrical outlet of the power supply system and the
power cable of the welding unit should be selected with consideration for the
actual power supply voltage.
Rated power supply voltage, 50/60 Hz, V
~ 230 V
Power supply voltage range
160 – 260 ; ±15%
Efficiency coefficient (at the rated current)
90 %
Welding current control range
8 – 160 A for PSI 160 STANDARD
10 – 200 A for PSI 200 STANDARD
12 – 250 A for PSI 250 STANDARD 230 V
Welding current at a load factor of 45 %, for
5 minutes
160 A dla PSI 160 STANDARD
200 A dla PSI 200 STANDARD
250 A dla PSI 250 STANDARD 230 V
Welding current at a load factor of 100 %,
for 5 minutes
107 A dla PSI 160 STANDARD
134 A dla PSI 200 STANDARD
167 A dla PSI 250 STANDARD 230 V
Maximum consumed power
4.2 … 5.5 kVA for PSI 160 STANDARD
5.5 … 7.0 kVA for PSI 200 STANDARD
6.9 … 9.3 kVA for PSI 250 STANDARD 230 V
Normal operating voltage for the manual arc
welding process
21 … 28 V
Normal operating voltage for the argon arc
welding process
10 … 18 V
Normal operating voltage for the
semiautomatic arc welding process
12 … 28 V
Summary of Contents for PSI 160 Standard
Page 1: ......
