PATON
ProMIG series
DC MMA/TIG/MIG/MAG
- 28 -
only then proceed with other actions. When leaving the machine, install a restrictive
plate which prohibits switching the machine on.
In order to ensure proper operation of the machine for many years, adhere to
several rules:
-
conduct inspection in accordance with safety practices within the established
time intervals (see "Safety rules" chapter);
-
if the machine is subject to heavy use, it is recommended to purge it with dry
compressed air once per six month.
Attention:
If the machine is purged from a
very short distance, electronic components may be damaged;
-
if the machine is very dust-laden, clean channels of the cooling system
manually.
9. GENERATOR OPERATION MODE
The power source can be operated from a generator upon the following condition:
When
working with
electrodes
Set current
value in MMA
and TIG modes
When working with wire
of specified diameter
in MIG/MAG mode
Minimum
generator
power
Ф
2
80 A at most
Ф
0.6 mm at most
2.9 kVA
Ф3
120 A at most
Ф
0.8 mm at most
4.5 kVA
Ф
4
160 A at most
Ф
1.0 mm at most
6.2 kVA
Ф
5
200 A at most
8.0 kVA
Ф
6, low-
melting
250 A at most
up to
Ф
1,2 mm
11.0 kVA
In order to ensure trouble-free operation:
Output voltage of the generator shall
not fall beyond the permissible range of 160~260 V; these are permitted values for
each phase, if a three-phase machine is used.
10. STORAGE RULES
A preserved and packaged source shall be stored in storage conditions 4 as per
GOST 15150-69 for 5 years.
A de-preserved source shall be stored in dry closed rooms at air temperature
not lower than plus 5 °
С. The rooms must be free from acid vapours and other active
substances.
11. TRANSPORTATION
A packaged source can be transported by any means of transportation, which
provide its integrity, complying with all transportation rules established for this type
of transport.
