Troubleshooting Flow Charts
40
8 ERROR CODE TABLE
Error
Code
E01
E02
E03
E04
E05
Error
Fallen below radius
range or angle
range exceeded
Radius range
exceeded or fallen
below angle range
Non-permitted
slewing zone (no
load area)
Operating mode
not acknowledged
or non permitted
slewing zone
Prohibited length
range
Cause
Fallen below the minimum
radius or gone past the
maximum angle specified in
the respective load chart
due to luffing up the boom
too far
Gone past the maximum
radius or fallen below the
minimum angle specified in
the respective load chart
due to luffing down the
boom too far
The slewing zone with load
is not permitted
A non existing operating
mode has been selected
The boom is in a non-
permitted slewing zone
Boom has been extended
either too far or not far
enough, e.g. if it is
prohibited to go beyond a
certain maximum boom
length or with load curves
for jibs where the main
boom has to be extended to
a certain length
Length sensor adjustment
has changed, e.g. the cable
slid off the length sensor
reel.
Elimination
Luff down the boom to a radius
or angle specified in the load
chart.
Luff up the boom to a radius or
angle specified in the load
chart.
Slew to permitted area
Set the correct operating mode
for the operating state in
question
Slew the boom to a permitted
area.
Extend/retract boom to the
correct length
Retract boom. Check the pre-
stress of the cable reel (cable
must be taut). Open the length
sensor and carefully turn the
length sensor pot counter
clockwise until loosened by
using a screw driver
Summary of Contents for DS 150
