Revised: July 27, 2017
Revision 7 of DOCU292, © Copyright
Page 9 of 26
2.2 Connect the G2 SatAimer to the Pason System
After you’ve positioned and levelled the dish skid, connect the power and data cables:
1. Connect the power cable to a 120 VAC rig power supply.
2. Run the Pason-supplied 15-pin Ethernet cable (shown below) from the Network
100 terminal on the dish’s electronics box to the Wide Area Network 2 terminal at
the bottom of the VSP network panel. This 15-pin cable run can’t exceed 60 m
(200 ft) for the trial’s 10/100 Mbps network.
3. After you’ve connected the cables, it can take up to five minutes before the user
interface is ready to open on the RMPC. If the user interface doesn’t open at first,
wait a couple more minutes and try again.
Note:
On earlier model network panels, the Wide Area Network 2 terminal is located at the top
of the panel. If connecting to the Network 2 terminal fails, connect to the Network 1
terminal and try again.
Figure 3: Pason 15-pin Ethernet cable
