TROUBLESHOOTING
T
O PREVENT INJURY
,
ALWAYS
DISCONNECT
THE
AIR
SUPPLY
HOSE
WHEN ADJUSTING
,
SERVICING OR
DISASSEMBLING THE TOOL
.
F
IRST
:
C
HECK THE
C
OMPRESSED AIR SUPPLY
Many of problems come from a faulty or inadequate
compressed air supply system. Before attempting to
repair the tool, the following points should be
checked:
• Check the pressure at the output of the compressor;
adjust to 80-100 psi (5.5-7.0 bar) as required.
• Check the tank pressure of the compressor & adjust
the start/stop limits.
• Check the air delivery system; a 3/8" hose is
recommended.
• Use fewer tools simultaneously; do not exceed the
capacity of the compressor or of the delivery
system.
• Drain water from the compressor.
S
ECOND
:
C
HECK FOR AIR LEAKS
At rest, this tool should not have any air leaks. Before
attempting to repair the tool and replace parts, check
the following:
• Check all seals in head, valve and piston
assemblies; replace if necessary.
• Check the top edge of main cylinder for burrs or
dents.
• Clean & lubricate the head and valve assemblies;
re-assemble the head assembly carefully.
• Check the interior of the head for scratches.
SUPPORT
Paslode warrants that newly purchased power
fastening tools, parts and accessories will be free from
defects in material and workmanship (excluding wear
parts) for the period shown below, after the date of
delivery to the original user.
90-DAY LIMITED WARRANTY will apply to all parts,
except those which are specifically covered by an
extended warranty.
EXTENDED LIMITED WARRANTY FOR ON SITE
CONSTRUCTION APPLICATIONS. A one year
warranty will apply to all housing and cap assembly
casings.
NORMAL WEARING PARTS. The following parts are
considered normal wearing parts and are not under
warranty
:
•
bumper
•
driving blade
•
o-rings & piston ring
WARRANTY STATEMENT
Paslode’s sole liability hereunder will be to replace any
part of accessory which proves to be defective within
the specific time period. Any replacement part or
accessories provided in accordance with this warranty
will carry a warranty for the balance of the period of
warranty applicable to the part it replaces.
This warranty is void as to any tool which has been
subjected to misuse, abuse, accidental or intentional
damage, used with fasteners not meeting Paslode
specification, size or quality, improperly maintained,
repaired with other than genuine Paslode replacement
parts, damaged in transit or handling, or which, in
Paslode’s opinion, has been altered or repaired in a
way that affects or detracts from the performance of
the tool.
PASLODE MAKES NO WARRANTY, EXPRESSED
OR IMPLIED, RELATING TO MERCHANTABILITY,
FITNESS, OR OTHERWISE, EXCEPT AS STATED
ABOVE, and Paslode’s liability AS STATED ABOVE
AND AS ASSUMED ABOVE is in lieu of all other
warranties arising out of, or in connection with, the use
and performance of the tool, except to the extent
otherwise provided for by applicable law.
PASLODE SHALL IN NO EVENT BE LIABLE FOR
ANY DIRECT, INDIRECT, OR CONSEQUENTIAL
DAMAGES WHICH MAY ARISE FROM LOSS OF
ANTICIPATED PROFITS OR PRODUCTION,
SPOILAGE OF MATERIALS, INCREASED COST OF
OPERATION, OR OTHERWISE.
TOOL WARRANTY AND LIMITATIONS
For more information or support, please contact our
customer service support at:
https://paslode.ca/contact-us/
