6
■
Depress the work contacting element and hold it
against the work surface before pulling the trigger.
Step No. 1
-
Grasp the nailer handle firmly. Pull
the magazine follower all the way to the rear of the
magazine until it is latched into its loading position
by the magazine latch.
■
After each fastener is driven, completely release the
trigger and lift the tool from the work surface.
TOOL OPERATION -
continued
Loading of Nails
Step No. 2
-
Insert a strip of fasteners into the top
of the magazine with the point of the nails facing the
nose area.
Step No. 3
-
Hold the follower firmly and press the
follower latch. Slide the follower forward until it
contacts the nails. The tool is now ready to use.
Driving of Nails
The tool is equiped with a sequential trigger to operate
the tool.
Nose Probe
The nose probe’s unique design allows you to accu-
rately and quickly install metal connectors.
Place the probe into the hole of the metal connector.
Hold the tool perpendicular to the metal connector and
pull the trigger.
Use only fasteners that meet Paslode specifications.
Use of fasteners that do not meet Paslode specifications
can result in damage to the tool or injury to the operator
or by standers.
Do not mix different length fasteners.
Remove all fasteners before changing fastener length.
WARNING
