®
Set Up the Software
PS
-
3213
3
013-14935B
•
In SPARKvue, select the Start button to begin
collecting data.
PASCO Capstone
Connecting the Wireless Sensor to a Tablet or a
Computer via Bluetooth
•
For PASCO Capstone, select Hardware Setup in the
Tools palette. The sensors in the list are ordered by
proximity to the wireless device.
•
Select the sensor with the address that matches the
XXX-XXX Device ID number on the sensor.
Collect Data
•
In PASCO Capstone, select a display in the main
window or from the Display palette. In the display,
use the <Select Measurement> menu to pick a
measurement to be shown.
•
Select Record to begin collecting data.
Troubleshooting the Wireless Llight Sensor
•
If the Wireless Llight Sensor loses Bluetooth
connection and will not reconnect, try cycling the ON
button. Press and briefly hold the button until the
status LEDs blink in sequence, and then release the
button. Start the sensor in the usual way.
•
If the sensor stops communicating with the
computer software or tablet application, try
restarting the software or application.
•
If the problem remains, press and hold the ON
button for 10 seconds and then release. Start the
sensor in the usual way.
•
Turn Bluetooth off and then turn it back on. Retry.
About the Battery
Battery Usage
Battery life is very important to making the sensor simple
and always ready to use, so all of the PASCO wireless
products are designed for long battery life. For example,
the sensor turns itself off after a few minutes of inactivity
to conserve battery life.
The Wireless Light Sensor includes a 3 V coin cell
battery (CR2032). We expect more than one year of
battery life, but the actual amount depends on factors
such as the data collection sampling rate.
Sensor Storage
If the sensor will be stored for many months, we
recommend that you remove the battery to avoid
damaging the sensor in case of a battery leak.
Maximizing Battery Life
One of the factors that affects battery life is the storage
temperature. Therefore, avoid storing the sensor in very
cold or very hot environments.
Battery Removal and Replacement
If the sensor’s battery status LED blinks red, the battery
may need to be replaced. Replacing the small,
disk-shaped battery involves opening the Battery Drawer
on the back of the sensor, removing the old battery,
installing a new battery of the same type, and closing the
Battery Drawer. The procedure uses a small, thin blade
screwdriver or a finger nail and a CR2032 three volt
battery.
•
Coin-cell Battery Replacement Pack (10 pack) -
PS-3504
NOTE: This battery is commonly available in electronic
and commercial stores.
Open the Battery Drawer
Hold the sensor top-side up. Use a thin blade
screwdriver or a finger nail to push down slightly on the
center section of the battery drawer. See 1.
1
2
1 cm
