Partner RP-100-300II, Programing Manual

Page: 50 / 56

-------------Thermal Printer-------------
49
units of the minimum horizontal movement amount.

In standard mode, the horizontal motion unit is used.

In page mode, the horizontal or vertical motion unit differs in page mode, depending on starting
position of the printable area as follow:
① When the starting position is set to the upper left or lower right of the printable
area using ESC T, the horizontal motion unit (x) is used.
② When the starting position is set to the upper right or lower left of the printable
area using ESC T, the vertical motion unit (y) is used.
③ the maximum right-side spacing is 255/180 inches for the paper roll and is approximately
35.983 mm {255/150 inches}. Any setting exceeding the maximum is converted to the
maximum automatically.
[Default] n1 = 0
，
n2 = 0
[Reference] GSP
F SW n
[Name] Turn quadruple-size mode on/off for Kanji characters
[Format] ASCII FS W n
Hex 1C 57 n
Decimal 28 87 n
[Range] 0
≤
n
≤
255
[Description] Turns quadruple-size mode on or off for Kanji characters.
*
When the LSB of n is 0, quadruple-size mode for Kanji characters is turned off.
*
When the LSB of n is 1, quadruple-size mode for Kanji characters is turned on.
[Details]
*
Only the lowest bit of n is valid.
*
In quadruple-size mode, the printer prints the same size characters as when double-width and
double-height modes are both turned on.
*
When quadruple-size mode is turned off using this command, the following characters are
printed in normal size.
*
When some of the characters on a line are different in height, all the characters on the line are
aligned at the baseline.
*
FS ! or GS ! can also select and cancel quadruple-size mode by selecting double-height and
double-width modes, and the setting of the last received command is effective.
[Default] n = 0
[Reference] FS!, GS!
ESC B n t
[Name] Printer Beeper Notification [For GP-80220II, III]
[Format] ASCII ESC B n t
Hex 1B 42 n t
Decimal 27 66 n t
[Range] 1<=n<=9, 1<=t<=9
[Description] Beeper functions when receipt comes.
• n is for beeper times.
• t is beeper lasting time, which is [tx50]ms.
ESC C m t n
[Name] Printer Beeper and Alarm Notification [For GP-802501]
[Format]ASCII ESC C m t n
Hex 1B 43 m t n
Decimal 27 67 m t n
[Range]
1<=m<=20, 1<=t<=20, 0<=n<=3