-------------Thermal Printer-------------
26
vertical motion unit]
·
The horizontal and vertical motion unit are specified by
GS P
.
·
The
GS P
command can change the horizontal (and vertical) motion unit. However, the
value cannot be less than the minimum horizontal movement amount, and it must be in
even units of the minimum horizontal movement amount.
·
In standard mode, the horizontal motion unit is used.
·
In page mode, the horizontal or vertical motion unit differs as follows,
depending on the starting point of the printing area:
①
When the starting position is set to the upper left or lower right of
the printable area using
ESC T
, the horizontal motion unit (x) is used.
②
When the starting position is set to the upper right or lower left of theprintable area using
ESC T
, the vertical motion unit (y) is used.
[Reference]
ESC $, GS P
ESC a n
[Name] Select justification
[Format] ASCII ESC a
n
Hex 1B 61
n
Decimal 27 97
n
[Range]
0
≤
n
≤
2, 48
≤
n
≤
50
[Description] Aligns all the data in one line to the specified position
n selects the justification as follows:
[Details] ·The
command is enabled only
when processed at the beginning of the line in
standard mode.
· If this command is input in page mode, the printer performs only internal flag operations.
·
This command has no effect in page mode.
·
This command executes justification in the printing area
·
This command justifies the space area according to
HT, ESC $
or
ESC \
.
[Default] n = 0
[Example]
ESC c 3 n (*)
[Name] Select paper sensor(s) to output paper end signals
[Format] ASCII ESC c
3 n
Hex 1B 63
33 n
Decimal 27 99 51
n
[Range]
0
≤
n
≤
255
[Description] Selects the paper sensor(s) to output paper end signals
·Each bit of
n
is used as follows:
Bit
Off/On
Hex
Decimal
Function
0
Off
00
0
Paper roll near-end sensor disabled
On
01
1
Paper roll near-end sensor enabled
1
Off
00
0
Paper roll end sensor disabled
n
Justification
0,48
Left justification
1,49
Centering
2,50
Right justification
