Partner PM-116, User Manual

Page: 6 / 28

2
2
Contents of packing
Prior to taking into operation your PM-116 monitor, please check whether the following parts are
included and undamaged:
1 PM-116 monitor
1 CD with DDC AP, Touch driver, Manual
1 Adaptor
1 VGA cable
3
Installation of the PM-116 Monitor
The following steps are necessary for the device to function properly:
1. Switch the computer OFF.
2. Connect the PM-116 monitor to the computer. (For best results, set the computers screen resolution
to 1366x768).
3. Switch your computer back ON.
4. Install Partner Monitor Controller.
5. Adjust the display for the graphic card in the computer by using Partner Monitor Controller Auto
Adjusting. This step is important for getting the best picture quality. (Chapter 6)
6. (Touchscreen Monitor Only) Install the touchscreen drivers for the corresponding operating system
(chapter 7).
NOTE
The PM-116 must be used with the power adaptor provided.
3.1 Cable Installation
The installation of the cables must be done with the computer switched off. Begin by connecting the
VGA cable, USB cable, then the power cable.
Once connected, turn the computer ON. After about 3 seconds, you should see the image on the screen.