P
AGE
41
E2
on
Event 2 on
E3
oFF
Event 3 off
rt
.10
Ramp Time
SP
0
Setpoint
E1
oFF
Event 1 off
E2
oFF
Event 2 off
E3
on
Event 3 on
St
.10
Soak Time
E1
oFF
Event 1 off
E2
oFF
Event 2 off
E3
oFF
Event 3 off
PLct
1
Profile Loop Count
dhru
0
Deviation Hold after Ramp Up-None
dhrd
0
Deviation Hold after Ramp Down-None
PEnd
0
Profile End Control-Abort-oFF mode
TABLE 3-5 ENABLE MODE CONFIGURATION PROCEDURE
To enter the Enable mode, press the UP and DOWN keys while in CtrL or oFF modes. All the
display lamps will light. After 10 seconds the lamps will go out and EnAb will be displayed.
Release the keys and the display will change to EtSt. Press and release the DOWN key and
each mode to be enabled/disabled will be displayed,. With the enable mode prompt for the
desired mode displayed press the SCROLL key to verify that the displayed mode is either on
(enabled) or oFF (disabled). Press the DOWN key to turn off the mode,press the UP key to
turn on the mode or press the SCROLL key to advance the display to the next enable mode
prompt. Use the Your Setting column in the table to record your programming.
A hardware jumper located on the Controller Board (See Appendix A-1, page 68) can be used
to lock/unlock the Enable mode. When the jumper is moved to the locked position, entry into
the Enable mode is not possible until the jumper is moved to the unlocked position.
1
Test Mode
EtSt
on or oFF
oFF
2
Calibration Mode
ECAL
on or oFF
oFF
3
Program Mode
EPro
on or oFF
on
4
Tune Mode
Etun
on or oFF
on
5
Manual (Stby) Mode
ESby on or oFF
on
6
Profile Continue Mode
EPC
on or oFF
oFF
7
Profile Entry Mode
EPE
on or oFF
on
8
Setpoint Change
ESPC
on or oFF
on
