7
Programming Step
Keystroke Combination
1. Enter Program Mode
* (Master Code) #
2. To
disable door open detection
OR
2. To
enable door open
detection
3. Exit
5 0 #
(factory default)
5 1 #
*
3.8 Set Strike-out Alarm
The strike-
out alarm will engage after 10 failed card/PIN attempts (Factory default is OFF). It can
be set to deny access for 10 minutes after engaging or disengage only after entering a valid
card/PIN or Master code.
Programming Step
Keystroke Combination
1. Enter Program Mode
* (Master Code) #
2. Strike-
Out OFF
OR
2. Strike-
Out ON
OR
2. Strike-
Out ON (Alarm)
6 0 #
(factory default)
6 1 #
Access will
be
denied
for
10
minutes
6 2 #
3. Exit
*
3.9 Set Audible and Visual Response
Programming Step
Keystroke Combination
1. Enter Program Mode
* (Master Code) #
2. Control Sounds
OR
2. Control LED
OR
2. Control Keypad Backlit
OFF = 7 0
#
OFF = 7 2
#
OFF = 7 4
#
ON = 7 1
#
ON = 7 3
#
ON = 7 5
#
(factory defaults
are ON)
3. Exit
*
3.10 Master Cards Usage
Using Master Cards to add and delete card / PIN users
Add a User
1. (Read Master Add Card)
2. (Read User Card)
Repeat Step 2 for additional user
cards
3. (Read Master Add Card)
Delete a User
1. (Read Master Delete Card)
2. (Read User Card)
Repeat Step 2 for additional user
cards
3. (Read Master Delete Card)
3.11 Users Operation & Reset to Factory Default
Open the door: Read valid user card or inputting valid user PIN
Remove Alarm: Read valid user card or inputting valid user PIN, or input Master Code #
To reset to factory default & Add Master Cards: power off, press the exit button, hold it and power
on, there will be two beeps, and the LED light turns into yellow, release the exit button, then read
any two cards(can be 125KHz EM card, 125KHz HID card or 13.56MHz MIFARE card, the LED will
turn into red, means reset to factory default successfully. Of the two cards reading, the 1
-st one is
Master Add Card, the 2
-nd one is the Master Delete Card.
Remarks:
1.
If no Master Cards added, must press the Exit Button for at least 10 seconds before release.
2.
Reset to factory default, the user's information is still retained.
