Commission and Testing
Check each coaxial cable connector and confirm that it cannot be easily loosened. Visually inspect the
coaxial cables to ensure that they are not sharply bent and are sufficiently secured and supported
between the antenna and the router.
Use a cellular device’s built
-in diagnostics to confirm the RSSI is higher than -75dB. Confirm the cellular
connection supports communications at required data rates.
Connect the GPS/GNNS cable to the GPS/GNNS receiver and check for satellite acquisition.
Connect the cellular/LTE & WLAN/Wi-Fi cables to the router and stow any unused coaxial cables to avoid
damage.
CAUTION
To comply with FCC RF Exposure requirements in section 1.1310 of the FCC Rules,
antennas used with this device must be installed to provide a separation distance of at
least 20 cm from all persons to satisfy RF exposure compliance.
DO
NOT
•
Operate the transmitter when someone is within 20 cm of the antenna
•
Install the antenna or mast assembly on a windy day
•
Install the mast close to power lines as it can cause serious injuries or death
WARNING
Watch out for overhead power lines. Check the distance to power lines before beginning
installation.
WARNING
This document gives detailed instructions to install an antenna to the best of our
knowledge. This document is for general information only. It cannot be used for a
warranty. Parsec Technologies Inc. will not accept any liability for any damage caused
by an antenna due to unknown variables.
Parsec Technologies
972-804-4600
[email protected]
Last Revised: 07.31.2023
