•
SDIO_1
SDIO_1 is multiplexed with UART_5, 6 and 7,
•
SDIO_2
SDIO_2 is multiplexed with CAM5.
SDIO_1 and SDIO_2 are compliant Default speed,
To be compliant to UHS-1 mode, an external power supply to
necessary. See section xx for an architecture example.
The maximum bus speed depends of the layout length and impedance.
The transmission line must be adapted to 50 ohm, at all available frequencies. It’s recommend
support
maximum
total
capacitor load
UHS50 card.
5.3.6
USB
5.3.6.1
USB_0
USB_0 is a host or device USB interface compliant with USB2.0 High Speed Specifications.
The VBUS_0 pin is an input signal.
When USB_0 are host, the power Supply VBUS_0 (5V) must be generate by the motherboard.
The pin “5” USB_0_VBUS of main connector must be conne
5.3.6.2
USB_1
USB_1 is a host only USB interface compliant with USB2.0 High Speed Specifications.
The power Supply VBUS (5V) must be generate by the motherboard.
The module doesn’t need to receive this voltage.
5.3.7
SPI
FC7100 has 4 SPI interfaces.
5.3.7.1
SPI_0
SPI_0 is multiplexed with the Ethernet
5.3.7.2
SPI_1, 2 and 3
SPI1,2 and 3 do operate as a master
5.3.8
MPEG TS
FC7100 has 2 Transport Stream MPEG
Confidential Information
with UART_5, 6 and 7,
with CAM5.
DIO_2 are compliant Default speed, High Speed, SDR12, SDR25, SD50
1 mode, an external power supply to switch between 3v3 to 1v8
for an architecture example.
ends of the layout length and impedance.
The transmission line must be adapted to 50 ohm, at all available frequencies. It’s recommend
capacitor load
C
L
of about 15pF for UHS104 card and about 30pF for
host or device USB interface compliant with USB2.0 High Speed Specifications.
The VBUS_0 pin is an input signal.
When USB_0 are host, the power Supply VBUS_0 (5V) must be generate by the motherboard.
The pin “5” USB_0_VBUS of main connector must be connect to this external power supply VBUS.
USB_1 is a host only USB interface compliant with USB2.0 High Speed Specifications.
The power Supply VBUS (5V) must be generate by the motherboard.
The module doesn’t need to receive this voltage.
with the Ethernet interface (same VDDO voltage).
as a master or a slave on a 3,3V bus. Its maximum clock frequency is 48 MHz
FC7100 has 2 Transport Stream MPEG interfaces.
27/39
Ref: OEM-2012-149
High Speed, SDR12, SDR25, SD50 and DDR50 mode.
switch between 3v3 to 1v8 is
The transmission line must be adapted to 50 ohm, at all available frequencies. It’s recommend
of about 15pF for UHS104 card and about 30pF for
host or device USB interface compliant with USB2.0 High Speed Specifications.
When USB_0 are host, the power Supply VBUS_0 (5V) must be generate by the motherboard.
ct to this external power supply VBUS.
USB_1 is a host only USB interface compliant with USB2.0 High Speed Specifications.
Its maximum clock frequency is 48 MHz.
