12
1.
Make a squareopening on the table surface with the size of 680*490mm,refer to Pic above
for the specification.
2.
After drilling a hole on the table surface, carefully remove shavings or sawdust before
inserting the appliance, as they could be sucked up by the appliance and compromising its
function.
3.
Make sure the table surface is level and square and that no part interferes with the space
required for installation.The kitchen units that are in direct contact with the
appliancemust be heat-proof(min. 80°).
Installing the appliance
1.
Dismantle the package and take out the instruction manual.
2.
6 pcs ST4*8mm screws will be used to install the two cabinet supporting feet onto the
blower cavity,from low to high,there are totally 4 groups of mounting holes on the
supporting feet,and installation height of the cabinet can be adjusted by customer
according to the interior space of the cupboard.Metal end on the cabinet is inlet,while
plastic end is outlet.In the direction of outlet,open a hole of about φ160mm in the
wall,corresponding to the 4 groups of mounting holes on the supporting feet.The distance
between the center of the hole on the wall and the floor is 125mm,150mm,175mm and
200mm from low to high.See Pic 1.
3.
According to the interior space of the cupboard,drill four φ8mm holes and put in four
φ8mm wall plugs.See Pic 2.
