EN
Main Gear Installation
1. Turn the model over so the bottom faces up.
2. Install the rear right and left landing gear struts
(
A
) in the fuselage using six screws (
B
).
Nose Gear Installation
1. Install the nose wheel post in the hole in front
of the fuselage.
2. Put the Z-bend of the steering linkage (
C
) in the
outermost hole of the steering arm (
D
).
3. Carefully turn over the model so it rests on the
landing gear. Put the end of the steer linkage
under the battery compartment inside
the fuselage.
4. Align the steering arm with top of the nose
wheel post so the arm is oriented as shown.
5. Install screw (
E
) to hold the arm on top of the
nose wheel post.
6. Connect the linkage clevis (behind the battery
compartment) to the rudder servo arm. See
Factory Settings for an illustration of the
linkages on the servo arms.
NOTICE:
Always ensure the steering linkage clevis
is adjusted correctly to make the model steer
straight when the rudder control is at neutral.
If disassembled, install wheels on the rear struts
using shoulder screws, washers and nuts. Make
sure the bushing side of the wheels are toward
the struts. Use a small amount of threadlock to
hold the nut on the shoulder screw. Use a small
amount of threadlock on the setscrew in the
wheel collar on the nose wheel.
Installing Landing Gear (Runway takeoff and landing)
B
2 X 8mm (6)
A
2 X 8mm
E
C
D
1. Install the collet (
A
) on the motor shaft (
B
).
2. Install the backplate (
C
), spinner backplate (
D
),
propeller (
E
) and spinner nut (
F
) on the collet
shaft. Use a tool to tighten the spinner nut on the
collet shaft.
3. Install the spinner (
G
) on the spinner nut (
F
)
using a screw (
H
). Make sure the spinner is tight
on the spinner backplate.
H
3 X 8mm
Installing Propeller
A
C
D
B
E
F
G
8
