Parkside PZKS 1500 B2, Operation And Safety Notes

Page: 15 / 130

10 GB / IE / NI
Safety measures must be defined to protect
the operator. They must be based on an
assessment of exposure during actual usage
conditions (all parts of the operating
cycle must be accounted for, e.g. periods
when the power tool is switched off and
when it is switched on, but not operating
under load).
Reduce the vibration risk by
- wearing protective gloves during use and
- limiting the working time and reducing
the actual operation time.
Residual risks
The machine has been built according to
the state of the art and the recognised
technical safety requirements.However,
individual residual risks can arise during
operation.
• Health hazard due to electrical power,
with the use of improper electrical
connection cables.
• Furthermore, despite all precautions
having been met, some non-obvious
residual risks may still remain.
• Residual risks can be minimised if the
"safety instructions" and the "Proper use"
are observed along with the whole of the
operating instructions.
• Do not load the machine unnecessarily:
excessive pressure when sawing will
quickly damage the saw blade, which
results in reduced output of the machine
in the processing and in cut precision.
• When cutting plastic material, please
always use clamps: the parts which
should be cut must always be fixed
between the clamps.
• Avoid accidental starting of the machine:
the operating button may not be pressed
when inserting the plug in an outlet.
• Use the tool that is recommended in this
manual. In doing so, your mitre saw
provides optimal performance.
• Hands may never enter the processing
zone when the machine is in operation.
Release the handle button and switch off
the machine prior to any operations.
7. Before starting the
equipment
• The equipment must be set up where it
can stand securely. Secure the machine
on a workbench or a stand with 4 screws
through the holes in the fixed saw table
(16).
• All covers and safety devices have to be
properly fitted before the equipment is
switched on.
• It must be possible for the blade to run
freely.
• When working with wood that has been
processed before, watch out for foreign
bodies such as nails or screws, etc.
• Before you press the ON/OFF switch
check that the saw blade is fitted
correctly. Moving parts must run
smoothly.
• Before you connect the equipment to the
power supply make sure the data on the
rating plate are dentical to the mains
data.
8. Attachment and operation
8.1 Attaching the saw
(Fig1/2/3/4/5)
Avoid unintentional starting of the
machine. During assembly and for all
work on the machine, the power plug
must not be connected to the mains
supply.
- Attach the carry handle (22) to the
machine head (4) with 2 x screws.
Before starting the equipment/Attachment and operation