Parkside PTSS 1200 B1, Original Instructions Manual

Page: 10 / 28

PTSS 1200 B1 GB
│
IE
│
NI
│
7 ■
Original accessories/auxiliary
equipment
■ Use only the additional equipment and acces-
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury.
■ Only the original guide rails may be used.
■ All blades used should conform to EN 847-1.
Operation
Fitting/changing the saw blade
Always remove the plug from the power socket
before working on the appliance.
NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
1. Activate the safety lock-out and push the
motor unit forwards.
2. Open the clamping lever . Release the safety
lock-out . The motor unit clicks into place. The
movement of the motor unit is blocked upward
and downward.
3. The clamping screw/washer
14a
is now in posi-
tion
14b
.
4. Press the spindle lock button and use the
Hex key to open the clamping screw/
washer
14a
.
5. Remove saw blade .
NOTE
► Ensure that the factory-fitted flange
X
stays in
place during installation and removal (see fig. A).
Fig. A
6. Fitting a saw blade is carried out in the
reverse order.
WARNING!
► The direction of rotation of the saw blade
and the machine must match.
Connecting the sawdust extraction
device
♦ If required, attach the adapter for dust extrac-
tion to the chip ejector .
♦ Connect an approved dust and chip extraction
device.
Check that the blade guard is
functioning
NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
♦ Activate the safety lock-out and lower the
circular saw.
♦ Check whether the saw blade rubs against
the blade guard and whether it moves back to
its starting position automatically.
Operation
Switching on and off
Switching on:
♦ Push the safety lock-out upwards and hold it
in position.
♦ Press the ON/OFF switch . Once the saw is
running, you can release the safety lock-out .
Switching off:
♦ Release the ON/OFF switch .
Setting the cutting depth (dive depth)
♦ Undo the screw for the cutting depth adjust-
ment and push the stop to the desired
cutting depth on the cutting depth scale :
–
without guide rail, see mark A.
–
with guide rail, see mark B.
♦ Retighten the screw for the cutting depth adjust-
ment .
X