Parkside PSFS 250 A1, Operation And Safety Notes, Page: 40 / 43

40 GB
Note:
Please use suitable accessories available
from your speciality retailer to cut wall tiles.
Installing sanding belts
Install the sanding belts
16
as shown in Figure C.
Setting the working depth
(see Fig. E)
Loosen the wing bolt
5
.
Slide the base plate
7
to the desired working
depth (to cut through completely set approx.
3.2 mm deeper than the material thickness).
The recommended maximum cutting depth for
wood is 13 mm.
Retighten the wing bolt
5
.
Plunge cutting
Insert the bit into the work piece at an angle
of 45°.
Slowly straighten the bit to an angle of 90° to
begin the cut.
Note: The base plate
7
must be flush with the
material surface.
7
Pivot handle (see Fig. F)
Pivot to horizontal
Press and hold the bevel stop
13
.
Turn the handle counter-clockwise from ver-
tical to horizontal until the bevel stop locks in.
Pivot to vertical
Press and hold the bevel stop
13
.
Turn the handle clockwise from horizontal
to vertical until the bevel stop locks in.
Using the rip fence (see Fig. G)
Loosen the wing bolts
9
on the base plate
7
and slide the guide bar for the circle- / rip
fence
15
through the two openings in the bot-
tom of the base plate
7
, with the rip fence
facing down.
Position the tool the desired distance from the
edge of the work piece. Tighten the wing bolts
9
to secure the circle- / ripe fence
15
to the foot
plate
7
.
Cutting circles (see Fig. H)
Note: the position of the guide hole depends on
the desired result, either inside or outside of the
edge of the circle: inside for holes, outside for
discs. The radius can be set from ca. 5 to 16 cm.
Make a circle on the work piece.
Mark the centre and drill a hole into the hole
(plunge cut).
Drill a guide hole on the edge of the circle
(plunge cut) (guide hole diameter 3 mm).
Loosen the wing bolts
9
in the foot plate
7
and slide the guide rod for the circle- / rip
fence set
15
through the two holes in the bot-
tom of the base plate
7
, with the centring tip
facing down.
Insert the centring tip in the middle of the circle.
Adjust the distance of the circle- / rip fence set
15
so as to plunge the bit into the guide hole at
the edge of the circle.
Lock the base plate
7
by tightening the wing
bolts
9
.
Press and hold the ON / OFF switch
4
to
power on the unit.
Slowly push the unit forward.
Operation Operation / Maintenance and Cleaning / Service / Warranty / Disposal