Parkside PSA 25 B1, Quick Start Manual

Page: 15 / 45

15 GB/IE
Ensure that the hose does not re-
wind itself. Doing so may result
in damage.
Never block the hose end with
your fingers or other objects
during use.
Installation must be performed
by a professional.
Discontinue using the product if
the plastic parts are cracked or
deformed. Always replace dam-
aged parts with genuine spare
parts.
3 Before installation
Make sure that you do not damage any cables,
power lines and water pipes during installation.
Check the installation area with a cable detec-
tor before drilling.
Remove the product from the packaging.
Check that the delivery contents are complete
(see fig. A).
Check to see if the product or the individual
parts are visibly damaged. If this is the case,
do not use the product.
3.1 Selecting the installation
location
Choose a stable weight-bearing installation
location.
Be aware of the weight of the product including
the water in the hose (see chapter „Technical
data“).
Choose an installation location where the full
180° swivel range of the hose box
3
can be
used (see fig. B).
Measure the distance to the tap so that the
connection hose
11
can be connected with
slack (see fig. C).
3.2 Selecting the installation
material
For installation on a concrete or brick wall, use
the accompanying screws
10
and wall plugs
8
(see fig. G). These are only suitable for
concrete or brick walls.
You will need a screwdriver with a head width
of 13 mm to screw in the screws
10
. This is not
included.
Use suitable screws and wall plugs for installation
on other materials or plaster thicker than 10 mm.
Ask a specialist retailer about wall plugs and
screws suitable for the respective wall structure.
4 Installation
Mark the drill holes at the specified height and
drill four holes (see fig. E).
Insert the wall plugs
8
into the drilled holes.
Mount the wall bracket
1
using the screws
10
.
The wall bracket
1
must be attached vertically.
Ensure that the wall bracket
1
is attached in
the direction of the arrow (the arrow must be
pointing upwards). For concrete walls and
brickwork, follow figure G.
Mount the hose box
3
on the wall bracket
1
(see fig. F). Hold the hose box
3
by the handle
2
. Guide the hose box
3
into the wall bracket
1
until the axle holes line up. Secure the hose
and wall bracket with the split pin supplied
9
(see fig. D). The bend in the open end of the
split pin
9
ensures that the split pin
9
does
not reopen.
Connect the tap connector
13
to the tap (see
fig. H). Turn the reducer
14
towards the tap
connector
13
in accordance with the size of
the tap‘s connecting thread.
Connect the hose piece
12
and the connection
hose
11
to the tap connector (see fig. I). Please
note that it will click audibly.
Connect the spray nozzle
7
to the hose con-
nector with the water stop
6
. Please note that
it will click audibly. Ensure that the spray nozzle
7
is closed (see fig. K).
The product is ready to use.