Parkside PMK 550 A1, Translation Of The Original Instructions

Page: 9 / 96

PMK 550 A1 ■ 6 │
GB
│
IE
Before use
WARNING! RISK OF INJURY!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance .
Changing the die holder position
(see fig . A)
The die position can be adjusted by 360° .
Four working positions offset by 90° are specified .
The working positions can be set as follows:
♦ Loosen the hex screw using the supplied hex
key .
♦ Turn the die holder into the desired working
position so that the respective hole in the die
holder is facing towards the hex screw .
♦ Retighten the hex screw using the supplied
hex key .
♦ Rotate the die holder slightly to check whether
it is fixed in the correct position .
Permissible material thickness
The maximum cutting capacity depends on the
material quality and strength .
The measuring grooves and on the die
holder can be used as a thickness gauge for the
permissible cutting thickness .
Never cut material thicknesses greater than those
specified in the technical data .
Fitting and removing the grooved pin
and the die holder (see figs . B + C)
♦ To remove the grooved pin and the die
holder
, undo the hex screw using the
supplied hex key .
♦ Pull the die holder from the appliance .
♦ Loosen the hex screw using the supplied hex
key so you can remove the grooved pin
from the tool holder .
♦ Insert the new supplied grooved pin into the
tool holder so that the hole in the grooved
pin is facing towards the hex screw .
♦ Tighten the hex screw firmly to secure the
grooved pin in place .
♦ Guide and insert the die holder via the tool
holder back into the appliance .
♦ Turn the die holder into the desired working
position so that the respective hole in the die
holder is facing towards the hex screw .
♦ Retighten the hex screw using the supplied
hex key .
♦ Rotate the die holder slightly to check whether
it is fixed in the correct position .
Operation
Switching on/off
Switching the appliance on
♦ Move the ON/OFF switch to the "0" position .
Switching the appliance off
♦ Move the ON/OFF switch to the "I" position .
Lubrication
♦ Apply standard machine oil to the cutting line
to extend the service life of the grooved pin
and the die .
This is particularly important when cutting
aluminium .