GB
│
IE
│
23
■
PLPRS 1.5 B3
Smoothing (Fig . F)
♦
Allow the hard wax to cool for a few seconds
(about 10 seconds) .
♦
After cooling, smooth any protrusion with the
planing grooves of the scraper . Use only
light pressure to smooth the protrusion .
Fine matching (Fig . G)
♦
For fine matching, now imitate the grain struc-
ture with a darker colour tone .
♦
Subsequently, again smooth any protrusion
with the planing grooves of the scraper .
Degreasing (Fig . H)
♦
To finish, remove the last hard wax residues
with the sanding sponge . Thereby the
gloss level of the surface will also be simulta-
neously matched . Job done!
Cleaning the planer grooves (Fig . I)
♦
Place the cleaning scraper on the plane
grooves of the scraper and scrape the wax
residues from the plane grooves .
Troubleshooting
In this chapter you will receive important informa-
tion for malfunction localisation and malfunction
remedies .
Malfunction causes and remedies
The following table will help with localising and
remedying minor malfunctions:
Defect
Possible
cause
Solution
The wax melter
tip does not
get hot .
The batteries
have been
inserted
incorrectly .
Insert the
batteries into
the wax melter
as indicated
in the battery
compartment
.
The batteries
are dischar-
ged .
Insert two new
batteries .
NOTICE
►
If you cannot solve the problem with the
aforementioned solutions, please contact the
Service Hotline (see chapter
Service
) .
Summary of Contents for PLPRS 1.5 B3
