53
GB
IE
Maintenance Interval Table
Machine part
Action
Before every
use
After 10 hours
of operation
Components of
the chain brake
Check, replace if required
Sprocket chain
wheel (20)
Check for wear/indentations,
replace if necessary
Saw chain (7)
Check oil, regrind or replace
if required
Guide bar (8)
Check, clean and oil
Guide bar (8)
Turn around
Automatic oil
system
Check, clean oil aperture if
necessary
Maintaining the chain bar
Use cut-protection gloves
when handling the chain or
the chain bar.
1. Switch off the device and remove the
battery (16) from the device.
2. Remove the sprocket chain wheel cov-
ering (12), the saw chain (7) and the
chain bar (8).
3. Check the chain bar (8) for wear. Re-
move burrs and straighten the guide
surfaces with a fl at fi le.
If the blade bar is damaged, repla-
ce it. Approved blade bars:
Oregon 575271,
Trilink M1431040-1041TL.
4. Clean the oil passages (
24), of
the chain bar, in order to guarantee a
trouble-free, automatic oiling of the saw
chain during operation.
5. Mount chain bar (8), chainsaw
(7) and sprocket chain wheel covering
(12) and tighten the chainsaw.
With the oil nozzles in good condi-
tion and the oil regulator set cor-
rectly, the saw chain will spray a
little oil off after starting.
Turn the chain bar
Use cut-protection gloves when han-
dling the chain or the chain bar.
The blade (8) has to be reversed regularly
after a working time of approximately 10
hours in order to ensure even wear.
1. Switch off the device and remove the
battery (
16) from the device.
2. Remove the sprocket chain wheel cov-
ering (12), the saw chain (7) and the
chain bar (8).
