16 GB
6. For a horizontal alignment of the tripod flat head
18
, loosen the
long handle
12
by turning anti-clockwise and move the handle up
or down as desired. If the air bubble of the spirit level
11
is located
exactly in the middle of the circle, the tripod flat head is aligned
horizontally. Then, tighten the long handle
12
by turning it clockwise.
7. If necessary, loosen the locking screw
13
to rotate the tripod flat
head
18
up to 360 degree horizontally to get desired side. Once
reached the desired side, tighten the locking screw
13
.
8. If necessary, loosen the locking screw
10
to adjust the angle of the
tripod flat head
18
up to 90 degree vertically to get desired angle.
Once reached the desired angle, tighten the locking screw
10
.
Securing the Cross Line Laser
Align 1/4”-thread
6
of cross line laser with the 1/4”-screw
8
of
the quick shoe and make sure to tighten the screw well by screwing
the metal key
9
clockwise. The metal key
9
is on the bottom side of
the quick shoe
19
.
Removing quick shoe from tripod:
If necessary to move the cross line laser to another location (or) would
like to store the cross line laser separately, it is always not necessary to
unscrew the cross line laser from tripod. User can just remove the cross
line laser together with quick shoe
19
from tripod by following below
steps:
1. Pull the lever
11a
on the tripod flat head
18
along the side.
2. Remove the quick shoe
19
.
3. Fold-up the metal key
9
on the bottom side of the quick shoe and
make sure that the cross line laser is firmly screwed onto the quick
shoe. Now the cross line laser is easy to move out separately from
tripod.
