15
GB
Working without the automatic
levelling system
Put the LOCK switch
3
into the position .
Hold down the H-button
1
until the red LED indicator
2
comes
on. Now the product will release two laser lines from the laser
beam opening
7
that are not levelled. Operation without automatic
levelling will always be indicated via the red LED indicator
2
.
Practical guidance
Always use only the middle of the laser line for markings. The width
of the line depends on the distance.
Working with the tripod
Setup and alignment
1. Pull all the three legs
17
of the tripod apart. The plastic ring
15
,
which is connecting all the three cross hinges will be moved to the
end of the middle column.
2. Release the blocking levers
16
and extend the legs until you get
your desired height.
3. Then, fold-back all those blocking levers
16
.
4. Check the straight positioning by using the bubble level
11
. If the
tripod is straight, the air bubble will be positioned in the centre of
the circle. If necessary, readjust the length of the legs
17
.
5. If additional height is necessary, loosen the locking screw
14
and
extend the centre column to desired height. Once reached the
desired height, tighten the locking screw
14
.
