Parkside PKA 20-Li A1, Translation Of The Original Instructions

Page: 45 / 69

PKA 20-Li A1
GB
│
MT
│
41 ■
Switching on and off
Switching on the appliance (air pump)
♦ Set the ON/OFF switch to the position
.
Switching on the appliance (compressor)
♦ Set the ON/OFF switch to the position .
♦ The appliance starts as soon as you switch on
the display
(see section "Display").
NOTE
► The compressor will not work if the display
is switched off.
Switching off the appliance
♦ Set the ON/OFF switch to the position .
Display
♦ Press the ON/OFF button to switch on
the display .
♦ After two seconds, the current pressure of the
connected item is shown.
NOTE
► If the compressed air hose is not connected
to a suitable item, the display indicator
shows "0".
♦ You can switch between "bar", "psi" and "kpa"
on the display
by pressing the ON/OFF
button .
NOTE
► The display (and also the compressor)
switches off after around three minutes of
inactivity.
► The compressor will not work if the display
is switched off.
► The compressor switches off automatically
when the preset pressure has been reached.
♦ Press and hold the ON/OFF button for
5 seconds to turn off the display .
Setting the pressure
♦ Press the "+" button or the "−" button to
set the desired pressure.
TIP
► When you press and hold the "+" button
or the "-" button for a little longer, the
pressure setting changes quickly.
Use
Inflation with blower hose
♦ Remove the valve cap of the item you want
to inflate.
♦ Remove the blower hose from the storage
compartment .
♦ Fit the connection of the blower hose onto
the air outlet . Screw it in tight by turning it
clockwise.
♦ Fit the appropriate adapter or onto
the blower hose .
♦ Push the adapter or into the valve of
the item.
♦ Switch the appliance on by moving the
ON/OFF switch
to the position .
♦ Once the desired level of inflation has been
reached, switch off the appliance by moving
the ON/OFF switch
to the position .
♦ Now remove the adapter or .
♦ Replace the valve cap on the item that you
have inflated.