Parkside PKA 20-Li A1, Translation Of The Original Instructions

Page: 44 / 69

PKA 20-Li A1 ■ 40
│
GB
│
MT
Before use
Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the charger before you remove
the battery pack from or connect it to the
charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Connect the battery pack to the high-speed
battery charger (see fig. A).
♦ Insert the mains plug into the mains socket.
The control LED
lights up red.
♦ The green control LED indicates that the
charging process is complete and the battery
pack
is ready for use.
ATTENTION!
♦ If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦ If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Allow the battery pack to click into place in
the appliance.
Removing the battery pack
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button to check
the status of the battery (see also figure A on
the fold-out page).
The status/remaining charge will be shown on
the battery display LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Operation
NOTE
► The appliance vibrates during operation.
Place it on a solid surface during operation.
There are four feet
on the bottom of the
appliance for this purpose.
ATTENTION!
► This appliance is not designed for contin-
uous operation.
The appliance may be used
for a maximum of 10 minutes continuous
operation. If the appliance overheats, remove
the battery pack
. Allow the appliance to
cool down completely and then try using it
again.
♦ Remove the required accessories from the
storage compartment
.
♦